Due to variation in individual skill, I offer no warranty for the result of your work. Build it at your own woodworking skill.
I do not assume any responsibility for any monetary damage or your bodily injury.
Try to build (or play) it at your own risk.
Copyright oggcraft.jp. All Rights Reserved. You are allowed to use this content for personal-hobby-use only.
You are prohibited to sell the kit or finished product or the plan that you have built on the basis of this content.
Do not over-load rubber bands. (max 6)
Do not aim other person.
Can you accept above? Then let's enjoy building.
- Materials -
MDF (4mm thick)
Wooden pin (3mm diameter)
- Tools -
Scroll saw
Drill press or pin vise
#240 sandpaper
Wood glue
Spray adhesive or double sided tape
- Assembling -
Stick each template on MDF board with a spray adhesive (or double sided tape).
Cut out each part with a scroll saw.
1
Glue C and D to A
2
Insert F into the hole of A.
3
Set E at F.
4
Glue B there.
5
Attach a rubber band (must be twisted) as trigger spring.
6
Completed!
- Loading and shooting -
1
Load two rubber bands to each holding place from the rear slit as shown in the picture below.
2
After first shot, when the trigger returns the 2nd rubber band automatically will be kicked up and feeded from the rear slit to the front holding hook.